Hilar 21.75'' H x 10'' W Desk

I bought this as an Xmas gift. The CPU is a little large so it has a tilt, which is concerning. However, its been up since December and hasnt moved, so its been good so far, I suppose! If you have a standing desk, remember to keep the underneath framework in mind when mounting. We chose to place it in front of the framework, but had to hang it extremely low because of how tall the CPU is. We made it work, but idk if this would work for everyone.

I bought this CPU holder to mount my desktop PC to the underside of my standing desk. My computer case is slightly larger than most, so I was a bit nervous that it would fit into the holder, but the dimensions on the listings were correct, and my PC fits snuggly. The CPU holder is well-built and very sturdy. It is made of higher-gauge steel than I would have expected, so I am pleasantly surprised.

I bought this add-on for my uninterruptable power supply unit which is about the size of a small computer chassis. It works fine and now my entire desk and its components are self-contained.

The piece is well made but there are only 4 small screws to hold it in place so initially I was skeptical. But once assembled, installed and filled with my gear it I realized I was wrong. It fits perfect and is a not going anywhere. Thanks SUDS!

Coupled with the cable manager, it keeps everything neat and tidy.

You'll have to drill right into your desk for this one. Good luck getting it straight. Buy a proper one from somewhere else. Turns out my case won't fit into this thing but only by about a quarter of an inch.

Holds the CPU well, I do wish it came with bigger/longer wood screws, and perhaps 2-4 more for added security, 4 short screws don't seem adequate for holding a CPU to the underside of a table.

It works. I've only had it for a few days, so I can't speak to how sturdy it is, but it's easy to use and put together. You almost definitely need a power drill to screw it in though, as the desk's facade is dense and trying to do get the screws to bite while screwing upwards with a hand screwdriver was impossible. I suppose I could have turned the desk upside down, but man is it is heavy.

I bought this to get the system off the floor. It is very sturdy and easy to install. I have a small form factor pc, and this is almost too big so it could handle a fairly large PC.

I bought 2 of these hoping to mount both of my towers. One is a midsize and one is a full. The midsize mounted great but the full size tower was too big and I ended up scratching my case trying to get it to fit. I ended up mounting it to my old desk that I have to my wife though and it works great for her pc