Ensemble d'empilage Samsung (SKK-8K)

Purchased from Best Buy as it was a third of the price, stacking kit was due to arrive the day after my delivery and installation product has been returned

I have a wf45t6000av washer and this is “supposedly” the stacking kit for it. I don’t think so. According to the directions, there should be two screws that go into the washer. There are two holes in the washer (one has a screw in it already) that appears to be where the stacking goes. However, these holes do not line up with the bracket. I’ve attached pictures to show how it doesn’t match up.

I don’t know if it’s a balance issue for the design but these brackets pull the dryer back about 3-4 inches and it doesn’t look right. It also causes the dryer to sit closer to the wall so then you have to pull the washer forward.I can not pull to far forward though because the doors will hit the opposite wall. I will also say that compared to other stacked washers this stacking kit doesn’t have any way for the front to be secured. Seems a little wobbly in my opinion.

these stacking brackets do securely fasten the dryer to the top of the washer, but my issue is with the fact that the brackets are bent so that that dryer sits further back by around 2" on the washer. the 50a8600 set we bought are already some of the deepest washer/dryers you can get, so clearance is at a premium, the vent pipe has to have plenty of space behind them. is there a reason that this bracket has to make the dryer sit back? can't the bracket be flat so that the dryer and washer sit equally flush at the front. just adding that extra 2 inches of space at the back for the dryer vent to fit could make all the difference for some people who would like these large capacity sets. with this current set up, our set barely allows the laundry room door to clear them.

[This review was collected as part of a promotion.] Works well, low cost, no issues installing, would recommend.