I have a wf45t6000av washer and this is “supposedly” the stacking kit for it. I don’t think so. According to the directions, there should be two screws that go into the washer. There are two holes in the washer (one has a screw in it already) that appears to be where the stacking goes. However, these holes do not line up with the bracket. I’ve attached pictures to show how it doesn’t match up.

I don’t know if it’s a balance issue for the design but these brackets pull the dryer back about 3-4 inches and it doesn’t look right. It also causes the dryer to sit closer to the wall so then you have to pull the washer forward.I can not pull to far forward though because the doors will hit the opposite wall. I will also say that compared to other stacked washers this stacking kit doesn’t have any way for the front to be secured. Seems a little wobbly in my opinion.

[This review was collected as part of a promotion.] Works well, low cost, no issues installing, would recommend.

I bought this stacking kit, SKK-8K but there was no instructions. I checked the Washer and dryer manuals and there were no instructions as well... Really, lucky for me I went online as was able to find how to install the kit via YouTube. Go YouTube.

[This review was collected as part of a promotion.] Bought this when I bought my stack. Easy to install and they work great.