Transformez votre espace avec ce ventilateur de plafond avec lumière Windmill, conçu pour combiner style dramatique et performance exceptionnelle. Doté de douze pales au fini noyer magnifiquement finies et d'un boîtier de moteur noir élégant, ce grand ventilateur de plafond industriel moderne crée un point focal étonnant tout en offrant jusqu'à 8918 pi³ / min de flux d'air puissant pour les grands espaces de vie.
La lumière DEL intégrée offre trois températures de couleur sélectionnables (3000K / 4000K / 6500K) et une gradation de 10% à 100%, vous permettant de personnaliser l'éclairage parfait pour chaque occasion. Le moteur à courant continu réversible silencieux offre un fonctionnement écoénergétique, six vitesses de ventilation, un mode de vent naturel et un contrôle du débit d'air saisonnier pour un confort tout au long de l'année.
Une télécommande facile à utiliser vous permet de régler la vitesse du ventilateur, l'éclairage, les réglages de la minuterie (1H / 4H / 8H) et la direction du flux d'air de n'importe où dans la pièce. Complet avec des tiges verticales de 5 po, 10 po et 24 po et compatible avec des plafonds inclinés jusqu'à 20 °, ce grand ventilateur de plafond avec lumière est un choix idéal pour les salons, les grandes salles, les salles à manger, les fermes et les espaces de vie couverts où le style , le confort et le débit d'air important sont les plus importants.
I put up this fan and overall I’m pretty happy with how it turned out. It’s big (did the 62) blades, modern industrial look—and once it was hanging the grey blades actually looked better than I expected. I’d have preferred white, but the grey doesn’t stick out in a bad way.
It’s a heavy fan. The motor especially is no joke, and the little warning sheet is right you need a real fan-rated box or solid mounting that can handle the weight. A regular light box isn’t going to cut it. Instructions are mediocre (pretty typical these days), so I mostly figured it out as I went. Easiest approach was to fully assemble the fan and light on the ground, run the wires, then hang it. Mounting the bracket and wiring in the remote receiver was straightforward. After that it was just clipping the two wires and hanging it.
It comes with three downrods I used the medium one (about 12”) for my angled ceiling. There are a ton of screws, so an impact driver is worth having, though I hand-tightened all the blade screws. Putting on all 12 blades from a ladder was the most annoying part. The glass diffuser is nice there’s a plastic piece inside that made me pause for a second, but it looks fine once everything’s together.
The big downside for me is that it’s remote-only—no pull chains or wall control. The remote itself works fine (6 speeds, three light colors, dimming, timers, reverse), but if it dies or gets lost I’m stuck hard-wiring it to a switch and living with whatever it defaults to.
For a large-room fan on sale in the mid-to-high 200s it delivers on looks and presence once it’s up. Just know it’s heavy, the install isn’t too big of a project, and you’re fully committed to the remote. Neil. US. Wed, 11 Nov 2026