The Original set arrived with a few issues. A few examples in pictures attached. Worst of which being the bent frames particularly the table since glass edge was exposed. However, I will say that issue with the wavy fabric in the bottom of the seat can be partially an assembly error on my part. That said, even after learning to apply minimal pressure when tightening the area I couldn’t always achieve a result without having the issue to a lesser degree. The replacement table looks great. The new chairs arrived without the bent pieces. However, I had the same issue again with the fabric at the bottom of chair so do be careful. Sits fine Last criticisms is the directions were good enough but that’s about it. It would have been nice to see a user manual with suggestions on how to store in winter, during wind etc.