Support à plantes à 4 niveaux pour l'intérieur et l'extérieur, support en métal à plusieurs niveaux pour plantes multiples, support à pot de fleurs pour tablette de jardin moderne (noir)

This is an attractive little plant stand. It is pretty narrow in diameter and thus a little wobbly. I'm concerned a gust of wind could knock it over. In the photos are the solar lanterns also purchased from Wayfair, which I love. I'll be adding another orchid in place of one of the lanterns and keeping one lantern on the bottom shelf. NOTE #1: the L-shape and U-shape pieces are attached by a screw, which did not go in straight. This was the hardest part of the assembly. Probably took 30 minutes trying to get it in. I tried WD-40. Two screws were included, and I tried both. Then realized that the square piece of metal soldered onto the short end of the L-shape piece where the screw goes in was unevenly soldered on. I tried hammering it without a cloth between the metal and the hammer, which chipped the paint off. This didn't help to get the screw in easier. It ended up going in crooked but is okay. Note #2: the instructions state not to fully tighten the screw until all is put together. Note #3: Don't do like I did and remove all parts from the plastic bags before assembly. The parts are numbered by stickers on the plastic bags. They are shown on the instruction diagrams also, but the pictures and print are tiny, so I needed a magnifying glass to identify the part numbers to the parts.