Tabouret de bar rembourré (Ensemble de 2)

Either missing parts or the legs are mislabeled. I tried for hours to make it work, but nothing lines up properly. The same parts (eg: leg “D”, which there are 2 of because there are 2 stools) have the holes drilled in different locations for the leg supports. Same is true of the other legs.

Great stools. My counter is 42 inches and these are perfect. However they were short 4 screws and had to go buy them.

So cozy

Utter disaster. Screws weren’t long enough to bind into the wood and legs had multiple cracks in them. I paid two task rabbits to try and put this together which only added additional cost

The top holes of one of the legs on both bar stools did not match up with the sockets on the bottom of the chairs. I had to partially tear down both barstools by removing the right and left stretchers. Then I could reposition the foreleg so that it could match up with the sockets. The factory needs better quality control as some holes on the underside of the chair was about 1/8" off, so the bolt could not be inserted if you followed the directions in the manual. I suggest installing the legs first, loosely, them the stretchers (bars between the legs). It took me more than 2 hours to complete 2 chairs. For tools I suggest you have a flex drive with the M4 or hex drive. You have to open the underside of the seat cushion along the Velcro to be able to access the holes.