Armoire bar cannelée moderne de 47 po de largeur avec tablettes réglables et lumière DEL

I absolutely love this piece! It was a pain to assemble, but I did it on my own and I’ll admit I’m not the most handy woman, but I’m decent enough hah. It took me over 3 hours but it’s beautiful. My problem is that the bottom shelf area is not tall enough for a standard liquor bottle. Shorter ones would fit, and the shelf is adjustable, but if you move it up, wine glasses no longer fit. So, if you want to display bottles, just an FYI that many won’t fit. Not a huge deal, the shelves behind the doors can be moved up to fit them there. Just depends on the aesthetic you’re going for.

This turned out beautifully! I love that it has a soft-close hinge, just like my kitchen cabinets. I chose not to install the LED lights. Assembly was a bit complicated. It took my husband about 3 hours to put together, even without the lights, and he’s very experienced at assembling furniture. I gave it 4 stars because the instructions skipped the upper back panel. We had to check the website to realize those panels needed to be installed.

I absolutely love this piece! It was a pain to assemble, but I did it on my own and I’ll admit I’m not the most handy woman, but I’m decent enough hah. It took me over 3 hours but it’s beautiful. My problem is that the bottom shelf area is not tall enough for a standard liquor bottle. Shorter ones would fit, and the shelf is adjustable, but if you move it up, wine glasses no longer fit. So, if you want to display bottles, just an FYI that many won’t fit. Not a huge deal, the shelves behind the doors can be moved up to fit them there. Just depends on the aesthetic you’re going for.

Started assembly and was still on step 1 when I discovered that the part marked 2 was not the same as the picture in the instructions. Neither side of supplied piece had the perimeter holes for the hardware as indicated. I did contact customer service and, as always, they were helpful. The problem has been escalated to the manufacturer so I can’t proceed with assembly. Will update with any progress.