Drain de tringle à passe horizontale longue pour le standard RP12517

This is the worst design i have ever seen. The ball should have been completey round instead of a half round so nut could be adjusted properly with wear from use over time. The flat side with only 4 places for the nut to rest on wears and can not be tightened evenly so it leaks like a siv.

I looked up the Arabella center set two handle bathroom faucet. It's discontinued after only being a couple years old, but underneath that shows the replacement parts. This horizontal rod was listed. It does not fit, is a different diameter and length of original. Mislead is an understatement. Perhaps with replacement parts list which models it works with. I bought two of these as it is a double sink. Im out my money and frankly shouldn't have to replace these already. I'm very disappointed with these faucets as I have had to change the o rings multiple times.

Although not as long as the original, it is a good replacement. The problem with this part (original and replacement) is that the plastic piece at the end will eventually break, as mine did on both faucets after 8 years. The metal rod should go the entire length.

It's simply too short. The specs and the web page for the product do not indicate what other longer rod can be used as an alternative.