The product is made of an adhesive substrate topped with an epoxy resin gel component; the embossed 3D epoxy resin offers a stunning visual impact. The tiles are thin and light; they can be installed in minutes over a clean and sleek surface without any mess or specialized tools and never crack with time. This self-adhesive wall tile is also an economical wall covering material; if you are getting tiled of the same design, peel them off and change to a new style. The item is lightweight and easy to handle, cut, and maintain; it will remain on your walls for as long as you wish. The product can also be installed directly over existing panels or smooth surfaces. The tiles are fire-retardant but can be deformed by excessive heat (176℉degrees Fahrenheit). The tiles can be installed above or behind most stoves. Keep direct heat sources - toaster ovens, cooking burners, etc., at least 12 inches from the backsplash panel's surface. It is not hot enough to melt the tile sheets themselves. The tiles are also resistant to the humidity of bathrooms (do not use them in the shower). For renters, Art3d peel-and-stick Vinyl Tiles are easy to remove with little to no damage, depending on the surface they were installed on. To make it easy, use a heat gun or a blow dryer to warm up each tile sheet to soften the adhesive. Then, apply concentrated heat, starting with the corner and pulling it softly with some force. Use a cleaning product to wash the wall and remove any excess glue left on the Tiles.