Vivace 9" x 18" Porcelain Wall & Floor Tile

Features

• This Product has PEI Rating of 4 (endurance and hardness indicator), and therefore is suited for all residential uses (walls and floors) and light-duty commercial applications
• Images and product samples are representative of a product’s potential characteristics. There is no guarantee that the sample product or images will 100% match the product received. Field and trim tile may not be an exact match. We reserve the right to make changes to product specifications at any time without notice. Tiles are subject to variations in colour, shade, sizing, surface texture, and finish. Prior to installation, the installer must blend tiles from several different boxes to achieve an even distribution of colour range. The installer must conduct a dry mock layout under proper lighting conditions prior to installation. It is the consumer’s responsibility to inspect the product prior to installation to ensure satisfaction. Once installed, the product is deemed accepted. Reference the most current TCNA handbook, ANSI, manufacturer's specifications, and the Bedrosians®' care & maintenance guide for installation, outdoor use, care, and maintenance information. Improper installation, application, and/or use voids warranty. For installation of all polished ceramic/porcelain, polished glazed ceramic/porcelain, and all honed ceramic/porcelain tiles, the manufacturer requires the use of a grout release or sealer prior to grouting. The manufacturer also requires the use of a grout colour that matches the predominant colour of the tile. Do not use acidic cleaners on polished ceramic/porcelain, polished glazed ceramic/porcelain, or honed ceramic/porcelain tiles. The maximum allowable installation offset is 33%. The minimum grout joint must be 3/16 inches. Please refer to the most current TCNA handbook. The manufacturer strongly recommends the use of a levelling system during installation.
• Water absorption: ≤ 0.5%.
• Note: Do not dry-cut porcelain or ceramic tiles when installing due to the potential for exposure to silica dust. Use a wet saw or a score and snap tool when cutting.