Contractor said the directions for assembly were not helpful at all. It took him some time to figure it out, but he did a good job and the shower has been fully functional without any problems

Solid made, top quality

It came well packed. We had a little issue with the rubber between the doors, but afterward we were able to adjust it and it seemed to work fine.

This door insert was a perfect fit for our customer who asked for an upgraded shower doors. The glass quality is top notch and covered in a protectant to reduce water spots. The shower door was super easy to install but you should make sure you have the door pulling or pushing the proper way prior to installation.

This is a stylish & affordable glass corner shower set. I am happy with the quality, and it looks great with the recommended shower pan. I have done a bit o installation in the past & was surprised how basic the instructions were. There are 8 steps with no words or measurements. That looked fairly easy, but I would HIGHLY recommend the following: If you need to drill through ceramic or porcelain shower tiles, use a Diablo 1/4" diamond core drill bit through the tile then switch to either a wood bit for studs or a masonry bit for cement block. It is very important to go directly to step #3 on pads or carpet to avoid damaging the glass. Then place the 2 connected sides on the shower pan exactly where they need to be secured. Use blue tape and a level to mark both sides of the left and right metal supports. Otherwise the chance of having them in the correct position and having the holes line up would be almost impossible. Remove the connected panels from the shower pan and take them apart again. Align the wall posts (Part #1) between the blue tape and use a sharp marker through the holes onto the tile as in step #1. Purchase stainless ST4 x 1 3/8" screws to replace the zinc based screws provided. 5 of the 8 stripped half way in and had to be carefully backed out and replaced. Overall, I'm very pleased with the results, and looks beautiful!