This unit was VERY DIFFICULT to assemble. Eight of the joints could not be made tight due to bent posts, misalignment and the clinch-nut not grabbing the post. You can see in the circled areas on the photos that I had to make 8 small gussets and glue them in place to get this assembled. Also, in one photo, you can see where one part split badly. I had to use a toothpick to push glue into the split and use clamps to repair the damage. I probably cursed more than 50 times during this 4-5 hour assembly process that spanned 3 days. In the end, I do like how the vanity looks, but if I could do it over I'd buy something else...pre assembled.
UPDATE: The pilot holes for the door hinges were not in the correct location. They are about 1/8" too high such that I can't install the door. Today, I'm having to figure out where to drill new holes. and hope that the door hinges will have enough adjustment to get the door aligned. Then, one of the ball bearings fell out of the drawer glides. Let's hope that the rest of them stay in place, so I don't need to replace all the drawer glides! I'm lowering the rating to 1 star. Can you rate something with zero stars? Don't buy this item!
