Haven’t installed them yet but OMG they stink so bad!! The off gassing is crazy!

This was a great addition to a closet in our master bedroom, which originally had bifold closet doors from 1980. It definitely brings the room to life!

This is basically 2 single 36" doors with 2 separate rails. They did not send a joiner, so you will need to order one before you can install it. This ommission delayed our installation. You will probably need a header board since it is unlikely that the predrilled holes in the rail will align with your studs. The doors are very heavy and of good quality. We also ordered plugs to cover the holes since the manufacturer only included cheap stickers.

They are very pretty doors, my suggestion is to put a piece of board before you put them into the wall for some added support! Overall we are happy with them

The doors were easy to put together and look great. We had no problem hanging them on the wall. We did decide to use a header because the pre drilled holes in the track did not line up with the studs. One design flaw there is no stop in the center to keep the doors from sliding past the middle point. We cut notches out of the piece they give you to join the two tracks together and screwed it on with the edge at the top instead of the bottom. If you don’t cut the notches out it will stop the doors 1” apart. We also installed magnets to hold the doors together.