Features

• Will darken the surface to make it look wet, bringing out any dull and faded colouring
• Protective surface film will reduce damage and deterioration caused by water absorption and surface abrasion
• Protective surface film will reduce the growth of mould, mildew, and algae on the surface
• Made from non-recycled US manufactured resins. UV resistant, breathable. When properly applied, the Armour AR500 can provide up to 1-3 years of life on an exterior surface before the need to recoat, and up to 2-7 years of life on an interior surface.
• Coverage: Porous Surfaces: Up to 175 FT2/gallon in one coat, Smooth Surfaces (once properly prepped): Up to 200-225 FT2/gallon in one coat. Coverage will vary depending on porosity, surface condition, application method, and the amount of material applied by the applicator. The above coverage rates are estimates and will vary. Two coats are suggested for even coverage and appearance.
• The Armour AR500 can be applied with a 3/8-1/2” nap roller, or an acetone/solvent resistant HVLP sprayer with Viton seals. For a consistent wet look and high gloss finish, apply two coats spaced 24 hours apart. Product should be applied in the late afternoon/early evening when air and surface temperatures are declining.
• The Armour AR500 is designed specifically to be used on unsealed concrete and concrete pavers. It can also be applied to concrete and concrete paver surfaces previously sealed with a solvent based acrylic. The Armour AR500 should not be used to seal clay brick, red Chicago pavers, flagstone, slate, tile, or natural stone. If you are looking to seal clay brick, red Chicago pavers, flagstone, slate, or natural stone, consider instead of the Armour WL550 or the Armour SX5000 WB.
• VOC Regulations: This product is 700 VOC and can be shipped to every state except AZ, CA, CO, CT, DC, DE, IL, IN, MA, MD, ME, MI, NH, NJ, NY, OH, PA, RI, UT, VA. If you live in a restricted state, please consider the Armor AR500 350 VOC or Armor AR500 50 VOC.