1 GAL Penetrating Matte Look Water Repellent Sealer For Concrete, Pavers, Brick, And Natural Stone

Features

• Will slightly darken the surface to bring out dull and faded colouring
• Works entirely below the surface and won’t leave a surface film
• Will reduce water absorption, reducing the damage and deterioration caused by water absorption such as cracking, spalling, pitting, mould, mildew, and algae
• Breathable, UV resistant, made in the USA
• When properly applied, the ArmorWL550 can provide up to 3-5 years of life on an exterior surface before the need to recoat
• Coverage: Porous Surfaces: Up to 175 FT2/gallon in one coat.Smooth Surfaces (once properly prepped): Up to 200-225 FT2/gallon in one coat. Coverage will vary depending on porosity, surface condition, application method, and the amount of material applied by the applicator. The above coverage rates are estimates and will vary. While most surfaces require 2 coats, overly porous surfaces may require more.
• Application: The Armour WL550 should be applied with a solvent/acetone-resistant HVLP pump sprayer. For best results, avoid applying with a roller. For consistent coverage, one even coat should be applied. Do not let puddle, product is not designed to leave a surface film. The product should be applied in the late afternoon/early evening when air and surface temperatures are declining. The product is designed specifically for unsealed concrete, brick, pavers, natural stone, and masonry.
• VOC Regulations: Due to VOC regulations this product can't be used in California. Instead, please consider the Armour SX5000 WB.
• If you are looking for a dramatic wet look, or have an overly porous surface, such as a paver, consider the Armour AR350 or Armour AR500 instead.