Remise extérieure en métal l 6 pi x P 4 pi

Where to start, lets just say this was a challenge for 3 mechanical inclined people so let me wish you luck if you arent. The directions say it will take 2 people 24 hrs to complete which is pretty accurate when you account for all the time spent figuring our the poorly written directions, cursing out the manufacturer, fighting over the direction, flipping the pieces you just put on because they are backwards, and all the mental breaks so you dont turn into the Hulk and crush the entire thing. But lets get down to the real details the bag of hardware labeled S2 are the washers (they have to be cut apart) you are to use with every F1 and F2 screws. Directions dont even mention them except in the hardware list. The roof should end with a short edge and make sure you put the edge on the exterior edge Parts 9, 11, 10L 10 R are attached to the inside and the edge faces inside, not out and over the edge. Made that mistake and had to redo. Part 20 for the door face inward with the thin lip hanging on the edge of D1 D2 (top and bottom) and the tab looking ends of 27, 28, 29, 30 31 go between 20 D1D2. GD goes on the inside of the of D1 D2 the second hole in from D1 D2s left and right side at the bottom. When i hung the doors i found i had a 1 foot opening because of A1 forcing me to move the one doors connection to G2 to the center 3 holes. I unscrewed the two screws closest to the center and put them into the original holes meant for G2 connection. Then using the F3 screws I pushed through part 20,27 the door into G2. The I took the 2nd screw through 20, 28 the door into G2. Pictures helped to make sure the parts were properly placed because the directions were the woooooorse! Heres to your 24 hrs of marriage counseling which will either end with clinking glasses or papers being served.

GOOD PRODUCT FOR WHAT I USE IT FOR.

This is the worst shed do not buy!! First of all it’s all scratched up and some pieces have plastic to be removed which is a nightmare! Second the instructions suck!!! Third the wholes aren’t in the right place and the tin is bent all over. I would send it back but needed it asap so keeping it. It’s like the old saying you get what you pay for!!!

This is kinda ridiculous to put together. There are no words with the instructions. It looks ok but kinda janky.

Super flimsy. Arrived with the paint all scratched from transit. I had help assembling it, and it still took all day. None of the holes lined up so we needed to drill new holes for most of it. Some of the pieces we too long so we had to use tin snips. Would not purchase again.