Mount-It Full Motion Adjustable Triple Monitor Stand | 3 Monitor Stand Fits 19 - 27 in. Screens

Just received this and put it together today, and the right monitor arm is slanted downwards. It was already like that before I even put my monitor on there, and now it's much worse. The left arm is fine, and is even with the center monitor, but the right one is considerably lower. And all monitors are substantially below the weight limit. Not impressed at all.

I have this set up with 3 24" monitors and I had to add a C-clamp to the base because they would fall over. Also the right monitor will sag down a full half an inch even with the adjustments maxed out. All of the screws are tight and I have no more adjustments.

Easy to setup. Base does not weight enough to hold the (older heavy) monitors. Simple push and it falls over. I made a clamp to add to the base stand to hold it on the edge of my desk.

good for the money, I chopped it up for a custom application, but the price was right and it worked for what I needed.

Great for the price. It's worth noting that the base is quite light, but they have included a way to drill it into your desk if the weight is too much for the base unit. It's holding 3x 24\ WQHD monitors happily

I was surprised at how heavy this stand is. I used it as a desk stand for three 19\ monitors. These are older LCD's so they are very heavy for what they are. I have zero worries about them toppling over with this mount.The only negative about this is the placement for the set screws to tighten the monitors after placement. The center is very difficult to tighten if the monitor is faced directly forward and I couldn't imagine how I would do it if I had to angle them up. I was able to tighten them correctly

I like that the middle monitor can be adjusted up/down vertically to account for slightly different sized outer monitors. My biggest issue is that both arms sag a little bit with 24\ monitors on them

Awesome buy. My 3 monitor system has created better production. Working perfectly. I didn't know how it would hold 3 monitors and not tip over, but it has been sturdy and I recommend it.

Exactly what I needed, very good quality build parts, it let's you adjust the screens with many angle approaches, it even has a height adjustment for every screen mount so if your screens have a height difference due to a bigger frame or mount point you can adjust them all still to be the same height ( gives you an inch +/- of margin to play with) - not that common on these products.Note that if you plan not to attach the center pole to the table and simply place it as is with the base plate, you will limit yourself to the angle of how much you can turn the side monitors curved to your direction since the center-weight-point will be moved further then the base playe and it will fall forward. In my pictures you can see the maximum angle to curve without mounting the pole to the table

I have 3 27 wide screens. They didn't fit. Felt well built