In Stock Only Yellow Switch Plates

To make a wall plate, two pieces of glass are cut, cleaned, stacked together and placed into a kiln. The kiln goes up to 1450°f, the glass becomes molten and fuses together to make one piece of glass. The glass goes to a water jet and the plate is cut out. Then, the glass is placed onto a mould and taken to 1300°f, the glass becomes elastic and gravity pulls the glass over the mould. Hot knobs call this process slumping. The glass spends about 48 hours in the kilns. Expect slight variations in colour and size.

Orange

Printed stainless steel metal plate with screws only. (Electrical Components are not included) Plates are printed with 3 layers of hard ink with UV treatment.

Good quality switch plate. Nice and colorful, paint does not chip off and durable metal. Comes with screws needed.. Lori. Saginaw, MI. Tue May 14 2024

Yellow

Printed stainless steel metal plate with screws only. (Electrical components are not included) Plates are printed with 3 layers of hard ink with UV treatment.

Perfect match to my wall!. Anonymous. Mon Jun 23 2025

Printed stainless steel metal plate with screws only. (Electrical Components are not included) Plates are printed with 3 layers of hard ink with UV treatment.

Printed stainless steel metal plate with screws only. (Electrical Components are not included) Plates are printed with 3 layers of hard ink with UV treatment.

To make a wall plate, two pieces of glass are cut, cleaned, stacked together and placed into a kiln. The kiln goes up to 1450°f, the glass becomes molten and fuses together to make one piece of glass. The glass goes to a waterjet and the plate is cut out. Then, the glass is placed onto a mould and taken to 1300°f, the glass becomes elastic and gravity pulls the glass over the mould. Hot knobs call this process slumping. The glass spends about 48 hours in the kilns. Expect slight variations in colour and size.